蜜桃一区二区三区四区_国产成人在线观看免费网站_欧美精品乱码久久久久久_亚洲综合图片区_久久久99精品免费观看_97久久精品人人做人人爽_亚洲免费成人av_欧美一区三区四区_亚洲一级电影视频_91精品国产欧美一区二区成人_国产精品动漫网站_成人网男人的天堂_国产精品入口麻豆九色_寂寞少妇一区二区三区_色婷婷久久久久swag精品_久久免费精品国产久精品久久久久

　　Large scale machining, not all materials can be fine processed, some materials are too hard, beyond the hardness of the machining parts, it is possible to break the parts, so these materials are not suitable for fine machining, except for the parts made of special materials, or laser cutting.

　　The materials for large-scale machining are divided into two categories: metal materials and non-metal materials.

　　As for metal materials, the hardness of stainless steel is the largest, followed by cast iron, followed by copper, and finally aluminum.

　　The processing of ceramics and plastics is attributed to the processing of non-metallic materials. Stainless steel material for large machining.

　　1. First of all, it is the requirement of material hardness. For some occasions, the higher the material hardness is, the better it is. It is only limited to the hardness requirements of machining parts. The processed materials cannot be too hard. If they are harder than the parts, they cannot be machined.

　　2. Secondly, the material is of moderate hardness, at least one level lower than the hardness of the parts. At the same time, it depends on what the function of the processed parts is to do and the reasonable material selection of the parts.

　　In a word, there are still some requirements for materials in large-scale machining, not all materials are suitable for machining, such as too soft or too hard materials. The former is not necessary for machining, while the latter is not.

　　Therefore, the most basic one is to pay attention to the density of the material before processing. If the density is too large, it is equivalent to the hardness. If the hardness exceeds the hardness of the machine (lathe tool), it cannot be processed. It will not only damage the parts, but also cause danger, such as the tool flying out and hurting people. For large-scale machining, generally speaking, for machining, the material material should be lower than the hardness of the cutter, so that it can be processed.